VOLTCRAFT VC940 - V06-09 Instruções de Operação descarregar pdf (Página 30)

MultiSystem 4010

Operating Instructions

Rev. 1.5 / 120816 english

Page 30 of 45

The calculation is CAN, since Patrick sends the data via CAN bus. The variable P stands for particle,

the index is 1 for particle size class ISO 4 µm, what is used as name, too. You have to enter a name

as units, here “SC” (= size class).

Then highlight „Parameter“ and press

to set the CAN parameters like shown here:

All parameters must be defined exactly like shown, otherwise there will be no communication. Specific

for the size class ISO 4 µm are the options „Identifier“ and „Offset“. For ISO size classes you should

enter an identifier resulting from the addition of the Patrick Node-ID (see type plate or Patrick

operation menu) plus 384 (here Node-ID 125: identifier = 125 + 384 = 509). For SAE size classes you

must add 640 to the Patrick Node-ID.

Press

to save the CAN parameters and again to save the settings for channel 8.

Configure channels for further ISO/SAE size classes

This is done in the same way like described for channel 8. Some parameters must be changed for

each size class (IP* = Identifier Patrick, see type plate):

ISO classes

Parameter

4 µm 6 µm 14 µm 21 µm

Channel C8 C9 C10 C11

Index variable 1 2 3 4

Name ISO 4 µm ISO 6 µm ISO 14 µm ISO 21 µm

Identifier IP* + 384 IP* + 384 IP* + 384 IP* + 384

Offset 4 5 6 7

SAE classes

Parameter

4 µm 6 µm 14 µm 21 µm

Channel C8 C9 C10 C11

Index variable 1 2 3 4

Name SAE 4 µm SAE 6 µm SAE 14 µm SAE 21 µm

Identifier IP* + 640 IP* + 640 IP* + 640 IP* + 640

Offset 4 5 6 7

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 44 45

Sem comentários

VOLTCRAFT VC940 - V06-09 Instruções de Operação Página 30